...
| Anchor |
|---|
| ConstituentModelConfigurationDialog |
|---|
| ConstituentModelConfigurationDialog |
|---|
|
Figure 3.
Constituent Model Configuration
Image Modified
Configuring constituents at nodes
...
Inflow node
In Source, the behaviour of constituents at each node varies. Select Constituents in the node’s feature editor to configure them. Depending on your requirements and the type of node, you can specify either a constituent’s load or concentration at a node. For example, you can only specify a constituent’s concentration on an inflow or a gauge node.
...
...
Only constituents with units of concentration (mass/volume e.g. mg/L) can be added or replaced using the Inflow node (Figure 4). Since constituent mass is a function of flow volume, the constituent mass will then be internally calculated by Source, depending on the volume of inflow at that point.
Figure 4. Inflow node (Constituents)
...