This section describes how to load time series data into Source and how to manually enter data in to tables. Additional sub-pages include:
| Child pages (Children Display) |
|---|
...
Figure 1. Loading a data source from within a component's feature editor
Anchor DataSourcesExplorer DataSourcesExplorer
Data Sources Explorer
| DataSourcesExplorer | |
| DataSourcesExplorer |
...
Figure 2 shows features of the Data Sources Explorer containing all data sources available in the scenario, both from time series data files and another scenario. Additionally, the nodes that some of the data sources are associated with are shown. Once a time series has been assigned to a node it is locked to that node, as indicated by the padlock.
Figure 2. Data Sources Explorer
...
| Info | ||||
|---|---|---|---|---|
| ||||
|
You can only load the result(s) of scenario run(s). Therefore, ensure that the donor scenario has been run before you load the scenario data source into the acceptor scenario.
...
| Info | ||
|---|---|---|
| ||
Note: If the Sets if a failed "Reload on run" will stop the current run button in the Data Sources toolbar is enabled (it is shown enabled in Figure 3), and the data source cannot be found, the scenario run will fail. However, if this icon is toggled off, Source will continue to use the data in its internal store, regardless of whether the source file can be found or the source scenario has been run yet. |
...
An example of a completed table is shown in Figure 10.
Figure 9. Steps to manually enter data tables
...
Figure 10. Manual data entry in tables (completed)