This section describes how to load time series data into Source and how to manually enter data in to tables. Additional sub-pages include:
| Child pages (Children Display) |
|---|
| Anchor | ||||
|---|---|---|---|---|
|
...
| Info | ||||
|---|---|---|---|---|
| ||||
|
You can only link to the result of a load the result(s) of scenario run(s). Therefore, ensure that the other donor scenario has been run before you load the scenario data source into the acceptor scenario.
To load the results of a scenario, either:
...
Once a scenario data source has been loaded, it will be listed in the Data Source Explorer. Its default name is New Group1. Grouped underneath the scenario data source are the results you selected to import from the donor scenario(s). The data source and time series can be renamed by right-clicking on the item and selecting Rename from the contextual menu.
...
- For File Data Sources, the source file cannot be open in another program; and the file must be located at the file path specified when you loaded your data. If Relative Path is also enabled, the data sources needs to be accessible at the same file path relative to your project.
- For Scenario Data Sources, the source donor scenario must be run before running the dependent acceptor scenario.
| Info | ||
|---|---|---|
| ||
Note: If the Sets if a failed "Reload on run" will stop the current run PIC button in the Data Sources toolbar is enabled (it is shown enabled in Figure 3), and the data source cannot be found, the scenario run will fail. However, if this icon is toggled off, Source will continue to use the data in its internal store, regardless of whether the source file can be found or the source scenario has been run yet. |
...