Link Routing

Types of link routing

Source supports three types of link routing - straight through routing (default), a lagged routing model or a Storage routing model. You are responsible for ensuring that you use the correct model for each link.

Note that you can configure constituents, ownership and ordering for a storage routing link only.

To change the link routing type:

• Right click on the link to display the contextual menu;
• Choose Routing Type; and
• Finally, click on the required link routing.

You can check which routing models are in use in a scenario using the Project Hierarchy. The example in Figure 3 shows that there are two types of links in use - lagged flow and storage routing.

Figure 3. Project Hierarchy (link models)

Straight through routing

All links are assigned straight through routing by default and have the following features:

• Water enters and exits such a link in the same time-step;
• There are no configuration parameters associated with straight through routing links; and
• You cannot configure fluxes, constituents or ownership.

Lagged flow routing

Lagged flow routing only considers the average travel time of water in a river reach. It does not consider flow attenuation. The flow entering a link exits at some whole number of time-steps in the future.

Figure 4 shows the feature editor for a lagged flow routing link and Table 2 lists the associated parameters.

Figure 4. Link (Lagged flow routing)

Table 2. Parameters for lagged flow routing

Modelling lagged flow routing with storage routing

A link configured for lagged flow routing is treated as a series of sub-reaches or 'divisions' of equal length, with the travel time in each division equal to one time-step. Water moves through the link progressively, without attenuation. You cannot configure fluxes, constituents or ownership on a lagged flow routing link. If lateral flows are significant and/or there is dead storage in the reach, you can model lagged flow routing using storage routing and the generalised non-linear storage option, as follows:

Compute the number of divisions, n, by dividing the average wave passage time by model time-step and round the result to a whole number. The result must be at least one (ie. n ≥ 1);

1. Configure a storage flow routing reach where:
   • n = number of divisions;
   • x = 1;
   • m = 1; and
   • k = model time-step.
2. If you need to account for lateral flows where n = 1 and the average travel time is a fraction of the model time-step (eg. a reach with a one day lag in a model with a monthly time-step), you can adjust k to a smaller value without affecting the shape of the hydrograph.

Lagged Flow when Fluxes are Significant or there is Dead Storage

If lateral fluxes (reach processes) are important, or there is dead storage in the reach, or both, and it is desired to lag flows without attenuation then it is necessary to use a Storage Routing link to do this. The approach that should be adopted uses generalised non-linear routing and is as follows:

• The lag is converted to the number of model time-steps, n, by dividing average travel time (ie. wave passage time) by the model time-step, and rounding off the result. However, the minimum value of n is one (i.e. n ≥ 1);
• Set up a routing reach where the number of divisions, ndiv = n, x = 1, m = 1 and K = dt (recalling dt is the model time-step). However, if ndiv = 1 and the average travel time is much less than the model time-step, and it is required to account for lateral fluxes but not otherwise change the hydrograph shape, then set K = travel time (recall that for stability K ≤ dt/x). For example, this would provide a means of adjusting for fluxes in a reach in a monthly model, where travel times are very small relative to the model time-step.

The solution process is the same as for other applications of storage flow routing.