Maps

For schematic scenarios, Source provides a background map image with overlaid nodes, resulting in an enhanced view of the current active scenario. The Map tab (Figure 1) shows nodes in a geographical setting, which can be set up using View » Maps or via the Scenario toolbar.

Note: This feature is currently only operational for an active Internet connection. Links and geographic projections are not displayed on the map.

Figure 1. Maps

For a current active schematic scenario, you can view different map styles using the Map toolbar (Figure 2):

Map (default) - shows a background map image with nodes overlaid;
Satellite - Shows a background satellite image with nodes overlaid;
Hybrid - Shows a combined map and satellite combined image with nodes overlaid; and
Snapshot - zooms the entire map to show all nodes in the map window.

Figure 2. Maps toolbar

Working with maps

Adding nodes to maps

Once your schematic is set up, you can add nodes to the map as follows:

In the Map tab, choose the node you wish to add to the map (at this point, the node will appear greyed out or disabled); and
Click Add Marker.

If location has not been specified, the node is positioned at the centre of the map (default). You can drag the node to the desired location or enter the location detail above the node list.

If location has been specified (using the Location control dialog), the node will be positioned at this location.

Note: If a Gauge node has a station ID specified, it will automatically be positioned at its location after it is added to the map.

Once a node is added to the map, it appears enabled in the node list.

Removing nodes from a map

Choose the node you wish to remove from the map; and
Click Clear Marker.

Scaling

There are two types of scaling available (as shown in Figure 1):

Zoom - expands or constricts the total geographic space rendered. This is synonymous to using the mouse scroll wheel; and
Node - changes the rendered size of the node, so it can be adjusted for readability, independent of the current zoom. This is useful when there are several nodes in a small geographical area.

Additional features

Hovering on top of a node will bring up a tooltip containing location details;
The panel below the map provides details at the location of the mouse pointer; and
An approximate processing times for loading the map is also shown below the map. This value is affected by the level of zoom on the map. As the zoom level is changed, a green bar appears at the bottom, indicating that the is in the process of being loaded.

Location control

You can set geolocation coordinates and elevations for nodes and reaches using the Location Control window (using View » Location Control). While it is not essential, it is convenient to set elevations with respect to Australian Height Datum (AHD). You can enter negative numbers for components that are below sea level, such as the lower lakes of the Murray. The elevation of a component is the zero point for that component. For example, the zero point for a storage is the lowest point in the storage.