Buffer Strips
Buffer strips are commonly used as a source control measure, particularly for management of diffuse runoff. Buffer strips are vegetated strips adjacent to drainage lines, rather than constructed vegetated channels, which are known as swales. Buffer strips are effective in the removal of coarse to medium sized suspended solids and bed loads and can be used as a pre-treatment to linear infiltration systems such as bio-retention systems. They also can assist in reduction of peak flows for smaller events and may promote infiltration dependent upon the underlying soil conditions. Buffer strip treatment only applies to runoff from impervious surfaces and can be used to represent catchment conditions where runoff from impervious surfaces needs to flow across grassed areas towards the stormwater drainage system.
Buffer Strip Properties
The treatment processes in a buffer strip are modelled by a set of simple transfer functions, derived from a review of worldwide literature (Fletcher, unpublished data):
TSSout = 0.27 + (1.8 x 10-5Hydraulic Load)* x TSSin
TPout = 0.52 + (8 x 10-6Hydraulic Load)* x TPin
TNout = 0.67 + (9.24 x 10-6Hydraulic Load)* x TNin
where concentrations are in mg/L, and Hydraulic Load is in m/year.
*For inflow concentrations below defined concentrations (TSS= 13.7mg/L, TP = 0.143 mg/L, TN = 1.680 mg/L), no treatment occurs.
Percentage of Upstream Area Buffered
This refers to the proportion of the Source Node’s impervious area which has buffer strips applied to it. For example, in a Source Node with 20 ha of impervious area, 2 ha (or 10%) may have buffer strips applied.
Buffer Area
This is a measure of the actual size of buffer strips, defined as the percentage of the Source Node impervious area. The default value is 5%. This means that the total area of buffer strip is equivalent to 5% of the Source Node impervious area.
Exfiltration Rate
Exfiltration from the buffer strip into the underlying soil can be modelled by defining the exfiltration rate (mm/hr). Representative exfiltration rates for different soil types are provided in the table over the page. The water that seeps from the buffer strip is lost from the catchment, and cannot re-enter the system downstream. Contaminants in the water that is lost to exfiltration are removed from the buffer strip, along with the exfiltrated water and are also lost from the catchment. Representative exfiltration rates for different soil types are shown in the following table.
Soil Type | Median particle size (mm) | Saturated Hydraulic Conductivity | |
---|---|---|---|
(mm/hr) | (m/s) | ||
Gravel | 2 | 36000 | 1x10-2 |
Coarse sand | 1 | 3600 | 1x10-3 |
Sand | 0.7 | 360 | 1x10-4 |
Sandy loam | 0.45 | 180 | 5x10-5 |
Sandy clay | 0.01 | 36 | 1x10-5 |
It is possible to view or save various inflows, outflows, water quality for the Swale. You need to select them to record before you run.
Buffer Node can be edited via Feature Table . Buffer node display on Feature Table shown below: